Configuring your Dialspeed Accelerator Software:

To configure the Dialspeed Internet Explorer, first right click on the icon in the system tray (down by the clock) and choose Settings...

That will bring up the Dialspeed Settings window.

The two sliders that you see adjust the speed/photo quality ratio. The default setting works great in most instances, however you can change the setting and see the effect it has on the picture of the watch shown. There is one slider for Internet Explorer and one for Outlook Express.

On the Automatic tab you can see the acceleration status of Outlook Express. If it says no acceleration, right click on the Outlook Express icon in the window and select Enable Acceleration.

On the Authentication tab you will see a place to enter your username and password for the accelerator. This is the same as your dialup username and password. This information should already be entered in if Internet Explorer asked you for it when you first installed the software. If it is not, you can enter it here and you will not be asked for it later.